Description
BULLARD CUTMASTER VERTICAL TURRET & BORING MILL
Serial Number 28205
Rebuilder Do-Rite, Electric Power Hour Meter Reads 1667.5
SPECIFICATIONS
CHUCK:
Diameter 42″
Number of Independent Jaws (Removable): Three
CAPACITY:
Swing with Side Head below top of chuck (Maximum) 56″
Swing with Side Head above top of Chuck (Maximum) 47″
Height Under Cross Rail: Maximum) 38″ Minimum 11″
TURRET HEAD:
5-Positions, Manual and Power Feed with Rapid Feed.
Swivels, Right/Left of center 30 degrees
Vertical Travel 37½”
Distance center of chuck to cutter tool center at extreme right 26″
Horizontal Travel on Cross Rail 18″
BORING HEAD: Manual and Power Feed with Rapid Feed
Swivels, Right/Left of Center 30 degrees
Vertical Travel 41″
Distance center of chick to cutting tool center at extreme left 26″
Horizontal Travel on Cross Rail 18″
SIDE HEAD: 4-Position Tool Holder
Manual and Power Feed.
Vertical Travel 24″
CHUCK RPM: 4.4, 5.3, 6.4, 7.9, 9.2, 11.2, 13.5, 16.6, 19.7,
24, 29, 35.6, 41.5, 50.4, 60.8, 74,.8, 88.8, 108, 130, 160
FEED RATES: 25, 35, 50 70 100, 150, 225, 300, 400, 600 ipm.
THREADS INCH and METRIC
MOTOR DRIVE: wired 480 volts, 3-phase
50 hp, 240/480volts
CONTROL: Main Start, Emergency Stop. Drive Start.
Chuck Drive Start/ Stop Buttons.
Chuck Jog Button. Chuck Brake/Run Switch.
CHUCK SPEED INCREASE/ DECREASE BUTTONS.
Coolant On/Off Buttons.
Additional control located at on each side of cross rail.
EQUIPPED WITH:
Electric Controls Allan Bradley and Real Time Controller Atcom 64.
Located on both end of Rail Start/Stop Buttons Jog Button and
Emergency Stop Button.
Auto Lube System.
Several Set of Jaws.
Rail and Side Head movement by hydraulic motor drives.
COMPLETE FACTORY SAFETY GUARDS