Description
FAMCO VERTICAL MILLING MACHINE with Bridgeport Milling Head
Model 120-3DM, Famco Base Serial Number M68VRP2
Bridgeport Milling Head, Serial Number J105285
SPECIFICATIONS
BRIDGEPORT SPINDLE HEAD:
Taper R-8
Collet Capacity ¾"
Quill Travel 6"
Quill Feed (per spindle revolutions)
.0015", .003", .006" IPM
SPINDLE SPEEDS: Four Step Pulley
80 thru 29560 rpm,
SPINDLE HEAD: Tilts Right/Left and Swivels Right/Left
SPINDLE HEAD: Swivels Right/Left
TABLE: (3) T-Slots
Size 10" x 42"
Longitudinal Travel, (X-Axis) 20"
Cross-Slide Travel, (Y-Axis) 10"
Vertical Travel Knee, (Z-Axis) 14"
FEEDS Table and Knee:
PLEASE NOTE Hydraulic Feed not connected.
Longitudinal and Cross, Manual and Power
Knee Vertical Rise and Fall, Manual and Power
Rapid Traverse Longitudinal and Cross
RAM:
Rotates 360 degrees
In/Out 14"
MOTOR DRIVES: wired 220 volts, 3 phase
Spindle 1 H.P. 220/440 volts
Hydraulic Feed Drives 1/5 H.P.
CONTROLS voltage 115 volts
Remote Operators Control Station with:
On/Off Buttons. Re-set Button.
Power Feed Rate Control.
Spindle Feed Rate Shift Lever.
Down/Stop/Up Switch.
Spindle Forward / Reverse Switch
COMPLETE FACTORY SAFETY GUARDS