Cincinnati Milicron 5-axis Hydrotel Profiler Miller, Model 20V-80, Spindle Speed 20-10,800 rpm, Table 30" x 80", 30 ATC, 20 hp, Serial Number 85-414Q-001-1 [M1748-16972]
Cincinnati Milicron 5-axis Hydrotel Profiler Miller, Model 20V-80, Spindle Speed 20-10,800 rpm, Table 30" x 80", 30 ATC, 20 hp, Serial Number 85-414Q-001-1 [M1748-16972]
Cincinnati Milicron 5-axis Hydrotel Profiler Miller, Model 20V-80, Spindle Speed 20-10,800 rpm, Table 30" x 80", 30 ATC, 20 hp, Serial Number 85-414Q-001-1 [M1748-16972]

Cincinnati Milicron 5-axis Hydrotel Profiler Miller, Model 20V-80, Spindle Speed 20-10,800 rpm, Table 30″ x 80″, 30 ATC, 20 hp, Serial Number 85-414Q-001-1 [M1748-16972]

Model Number: 20V-80

Serial Number: 85-414Q-001-1

Reference No: M1748-16972

Condition: Used

Mfg Date:

Model Number 20V-80

Serial Number 85-414Q-001-1

Reference Number M1748-16972

Read More
1-213-627-2847
Categories: , ,

Description

CINCINNATI MILACRON 5-axis CNC HYDROTEL VERTICAL MILLER
     Model 20V-80,   Serial Number 85-414Q-001-1

SPECIFICATIONS
SPINDLE: ONE
   Taper 50 NS
   Speeds Range 23 steps with 10% trim 20 to 10,800 RPM
           Spindle braking method, Electrical
AUTOMATIC TOOL CHANGER: 30 Positions
      Securement: Bayonet type drawbar.

PLEASE NOTE: At this time Tool Changer Arm has been disconnected, and taken off,
     as previous owner did not wish their operator to use tool change
TABLE: 
   (7) T-Slots.    Size 13/16".     Centers 5"
   Working Surface, 30" W x 80" L
   Maximum Weight on Table 7,000 lbs.
TABLE TOP to SPINDLE NOSE  5" Minimum,
                                                  29" Maximum 
TABLE TOP to UNDERSIDE of CROSS SLIDE WAYS 32"
TRAVEL:
   Longitudinal Travel (X-Axis)	 80"
   Cross-Slide Ram Travel (Y-Axis) 30"
       (15" either side of table C/L)
   Vertical Head Travel (Z-Axis) 24"
   Tilt Movement Head (A-Axis) +25 degrees to –25 degrees
   Tilt Movement Head (B-Axis)  +25 degrees to –25 degrees
FEEDRATES:  Infinitely Variable
   X-Axis, Y-Axis and Z-Axix  0- 140 IMP
   A and B Axis… 0- 160 IMP
   Rapid Traverse Rate is maximum feed rate for each axis.
MOTOR DRIVE: *Motors wired 460 volts, 3-phase*
   Spindle	20H.P, 230/460 volts
   Feed Drives	 Getty’s DC Motors
CONTROLS: *Remote Low Voltage Control
   Alan Bradley Acramatic CNC,
   Model 2.1, with: CRT & RS232 Port
 EQUIPPED WITH: Tape Reader.     Coolant Pump with Tank.
 COMPLETE FACTORY SAFETY GUARDS

Related products...