42 inch Bullard Cutmaster VTL & Boring Mill with 3-Jaw Chuck and Height Under Rail 38 inch, 5-Position Turret, Boring & Side Head, Speed 4.4 thru160 rpm, Feed Rate In-mm , Serial Number 28205, Inventory Reference B6006-L6454-7101

BULLARD CUTMASTER VERTICAL TURRET & BORING MILL
 Serial Number 28205
Rebuilder Do-Rite,   Electric Power Hour Meter Reads 1667.5

SPECIFICATIONS
CHUCK:
     Diameter   42″
     Number of Independent Jaws (Removable): Three
CAPACITY:
    Swing with Side Head below top of chuck  (Maximum)  56″
    Swing with Side Head above top of Chuck (Maximum)  47″
Height Under Cross Rail: Maximum)  38″      Minimum 11″
TURRET HEAD:
    5-Positions, Manual and Power Feed with Rapid Feed.
    Swivels, Right/Left of center   30 degrees
    Vertical Travel  37½”
    Distance center of chuck to cutter tool center at extreme right  26″
Horizontal Travel on Cross Rail 18″
BORING HEAD: Manual and Power Feed with Rapid Feed
    Swivels, Right/Left of Center 30 degrees
    Vertical Travel  41″
    Distance center of chick to cutting tool center at extreme left  26″
    Horizontal Travel on Cross Rail  18″
SIDE HEAD: 4-Position Tool Holder
Manual and Power Feed.
    Vertical Travel  24″
CHUCK RPM: 4.4,  5.3,  6.4,  7.9,  9.2,  11.2,  13.5,  16.6,  19.7,
24,  29,  35.6,  41.5,  50.4,  60.8, 74,.8, 88.8, 108, 130, 160
FEED RATES: 25, 35, 50 70 100, 150, 225, 300, 400, 600 ipm.
THREADS INCH and METRIC
MOTOR DRIVE: wired 480 volts, 3-phase
    50 hp, 240/480volts
CONTROL: Main Start, Emergency Stop. Drive Start.
Chuck Drive Start/ Stop Buttons.
    Chuck Jog Button. Chuck Brake/Run Switch.
    CHUCK SPEED INCREASE/ DECREASE BUTTONS.
Coolant On/Off Buttons.
Additional control located at on each side of cross rail.
EQUIPPED WITH:
Electric Controls Allan Bradley and Real Time Controller Atcom 64.
Located on both end of Rail  Start/Stop Buttons Jog Button and
Emergency Stop Button.
Auto Lube System.
Several Set of Jaws.
Rail and Side Head movement by hydraulic motor drives.
COMPLETE FACTORY SAFETY GUARDS