Description
ORTON VERTICAL SHAPER (ROUTER)
Model F, TILTING SPINDLE, Serial Number F-63-38473
SPECIFICATIONS
CAPACITY:
SPINDLE:
Tilting: From 90 degrees Vertical, Unit adjustable 45 degrees under to 30 degrees outward.
Horizontal & vertical adjustment to bring the top of cutter and the cutting circle to the point
of tilt. A vertical height adjustment allows for material thickness. 4" thick material can be cut at full tilt.
Collet Type: Capacity 1"
Taper, Brown & Sharpe 11
Vertical Adjustment 2½" by Hand Crank
Power & Hand Tilting of spindle with degree indicator.
SPINDLE SPEED 10,000 rpm
OFFSET GUIDE PIN: Adjust Up & Down Manually
TABLE SIZE: 40½" LR x 60" FB
MOTOR DRIVES: wired 460 volts, 3 phase
Spindle Drive Motor 10 hp, 385 volts, 110 cycles.
Frequency Converter Varidyne Varidrive (For spindle drive motor) 15 hp, 120v minimum -385v maximum
32 thru 100 cycles, RPM 950 thru 3000, Constant Tork Drive
Power Feed 1/3 hp. 220/440 volts
Power Tilt 1/3 hp. 220/440 volts
Vacuum Pump ¾ hp. 220/440 volts
CONTROLS: wired 115 volts
Nema 12 Electrical Combination Control Station
with: Remote Start/Stop Buttons. Rapid Stop Button. Up/Close Buttons.
Vacuum Pump Start/Stop Buttons. Tilt Forward/Reverse Buttons.
Feed Speed Control. Speed Indicator.
EQUIPPED WITH:
2-Vacuum Part Holders with Trigger release.
1- Material Feed System: Variable Feed Geared Drive, w/ Cable winch, fitted with quick- release
cable drum for fast return.
1-Power Spindle Tilting.
1-Overarm Support for Offset Guide.
1-Spray Mist Bearing Lubricator with Regulator, Low Oil Sensor & Low Voltage Air Valve.
1-Spindle Foot Brake with Electric Current Shut Off.
1-D.C. Spindle Motor Brake, Solid State.
1-Emergency Off foot switch.
1- Collet Holder with Collet
COMPLETE FACTORY SAFETY GUARDS