5″ x 5″ x ½” Mubea 550-510 Universal 62 tons Ironworker with Punch capaity 1¼” thru 9/16″ Diameter, Notcher, Rod Cutter and Shear, Serial Number 0171898404821, Inventory Reference P8915-9867

Description

MUBEA UNIVERSAL HYDRAULIC IRONWORKER
  Model 550-510,     Serial Number 0171898404821

SPECIFICATIONS:
PUNCHING CAPACITY:
     Nominal Tonnage 62
     Punch Diameter thru thickness 1¼" thru 9/16"
     Largest Hole 4"
     Stroke, adjustable 0 thru 2⅜"
     Depth of Throat 20"
     Speed: ¾ Travel 42 CPM
     Speed Full Travel 14 CPM
     Work Height 41⅜"
     Swing Away Stripper & Guard
ANGLE STATION:
     Angle at 45 Degrees 3" x 3" x 5/16"
     Angle at 90 Degrees 5" x 5" x ½"
     BAR SHEAR: 
     Round 1¾"
     Squares 1⅝"
     Channels & I-Beams 90º at 4"
     Tees 90º at 2¾"
     Sliding type Support Plate.
     Adjustable double screw type Hold Down.
FLAT BAR SHEAR: 
     Capacity 9" x ¾"   or   14" x ½"
     Knife Length 14-3/16"
     Angles 45º (one leg) 3" x 3" x 5/16"
RECTANGULAR COPER CAPACITY:
     1¾" deep x 3½" wide x 3/8" thickness
 EQUIPPED WITH
     Punch -  Plate Shear – Notcher -
            Bar Shear,- Angle Shear
     (Two) each Anti-Repeat Foot Switch to actuate
           Punch End and Shear End.
     One Shot Lubrication.
     Point of Operation Safety Guards at each cutting station.
MOTOR DRIVE: Wired 230 volts, 3-phase
     Hydraulic Pump 7½, 230/460 volts
CONTROLS:  Wired Low Voltage
     Main Electrical Control Keyed On and Off.
         (Located on Side Punch End.)
     Shear or Notching Switch.
     Keyed Lock Switch for Punch Depth Control.
     Keyed Lock Switch for Punch Depth Control
COMPLETE FACTORY SAFETY GUARDS

Dimensions: 64" L x 30" W x 62" Height
Approximate weight 3700 lbs.