8″ Coast Wallace Model 8HRD Tube and Pipe Bender Counter Clockwise Right 210 Degrees with Hydraulic Mandrel Extractor, Serial Number 90, Inventory Reference B1804-6633

Model Number: 8HRD

Serial Number: 90

Reference No: Bender, Pipe and Tube, & B1804-6633

Condition: Used

Mfg Date:

Model Number 8HRD

Serial Number 90

Reference Number Bender, Pipe and Tube, & B1804-6633

Description

COAST/WALLACE TUBE, PIPE BENDER
Model 8HRD, Type: Rotary Draw, Serial Number 90
SPECIFICATION
CAPACITY BEND: Outside Diameter  8″
Bend Radius to Centerline, (Angle Maximum)   48″
ARM ROTATION, Counter clockwise, Horizontally thru   210 degrees Arc
PRESS DIE LENGTH  174″
PRESS DIE (Accommodate Length)    14’–8″
PRESS DIE CROSS TRAVEL   54″
WIPER DIE CROSS TRAVEL on ARM   37½”
DIE BLOCK MOUNTING POST DIAMETER      3
MANDREL EXTRACTOR:  (Hydraulic), stroke   16″
FOLLOWER and CLAMP DIE TOGGLE LEVERS: (Automatic Operation)
MOTOR DRIVE: Wired 440 volts, 3 Phase
Hydraulic Pumps   20 H.P. & 3 H.P. 220/440 volts
CONTROLS: ACCU-BEND Sequential Programmer
    Safety Shut Off Switch.
    Start/Stop Buttons.
    Manual and Auto Cycle.
    Automatic Sequence Buttons.
    Fixed Overbend Dial.
    Proportional Overbend Switch.
    Arm Return.  Press Die In/Out Clamp In/out.
    Arm Forward/Return.
    Mandrel In/Out.
    Boost Advance/Return.
    Auto Cycle Forward/Reverse.
    Vent, Pilot Pressure Selector.
    Slow Switch, Jog Switch, Lubricator Switch.
EQUIPPED WITH:  Form Dies:  (1) 6” I.P.S. x 48-3/8” Centerline Radius.
    (1) 6″ I.P.S. (3-D) x 37¼” Radius (PTI-101488), 5″ I.P.S. (3-D) x 30″  #875
    (1) 5 I”.P.S. (3-D) x 38¼” Centerline Radius 01487-1,
Clamp Dies and Pressure Dies:  (1) 5″ and 7” Combination, (1) 6″ and 12″ long
    (1) 4¾” and 5″ Combination x 58″ Long, (2) 6″ and 4 Combination x 58″ Long
    (1)6″ and 4½” Combination x 58” Long(1) 6″ and 4″ Combination w/ 3″ Radius Insert x 58″ Long

COMPLETE FACTORY SAFETY GUARDS